返回列表 發帖
是的,两边都set yes,看看是否有改善。

PSTN silence detection
VoIP slience detection

不知道是否有 ...
角色 發表於 2011-3-5 11:42

要再測試一下

TOP

As spoken, look into the setting in silence detection in asterisk as well

TOP

As spoken, look into the setting in silence detection in asterisk as well
ckleea 發表於 2011-3-5 15:06

係咪呢個 post 所提及既野呀?
http://www.telecom-cafe.com/foru ... &extra=page%3D3

TOP

之前Qnewbie 兄說在Asterisk PSTN 方面係work 的,但在SIP 方面就唔work,其實你PSTN 定 SIP 問題呢?

IP01在Silence Detection 方面其實沒有太多調較空間,反而在SPA3102 還有些地方可以控制一下。

TOP

你超高 line-voltage 的問題解決咗未?  呢樣野都影響SIP接出接入掛線問題的。

TOP

我係 VOIP 被 Hold, 而超高 line-voltage 我可以點解決?

原本沒有數值的現在加返.

IP01-2.jpg (105.52 KB)

IP01-2.jpg

TOP

本帖最後由 bubblestar 於 2011-3-5 17:57 編輯

IP01 SIP.conf 基本上我跟你的差不多,但rtpholdtime out 一定要大過 rtptime out 的,以前我set 120/60,現在用 300/60。

至於你之前超高 SPA3102 line voltage,老實說一定有影響。 而且聽你說現在是借公司線用,公司又是用緊PBX,情況較複雜,很難推想問題出在那裡。
我現在沒有插SPA3102使用,稍後再拿出來看看SETTINGS,到時再試下睇下是否幫到你手。


[general]
context = default
allowoverlap = no
bindport = I use a port number other than 5060 in my case
bindaddr = 0.0.0.0
srvlookup = yes
allowexternaldomains = yes
allowguest = no
allowsubscribe = yes
allowtransfer = yes
alwaysauthreject = yes
autodomain = no
callevents = no
canreinvite =
checkmwi = 10
compactheaders = no
defaultexpiry = 120
domain =
dtmfmode = auto
dumphistory = no
externrefresh = 10
fromdomain = This is set to be my DDNS address
g726nonstandard = no
jbenable = no
jbforce = no
jbimpl =
jblog = no
jbmaxsize =
jbresyncthreshold =
language = en
maxcallbitrate = 384
maxexpiry = 3600
minexpiry = 60
mohinterpret = default
mohsuggest =
nat = yes
notifyringing = yes
pedantic = no
progressinband = never
promiscredir = no
realm = asterisk
recordhistory = no
registerattempts = 0
registertimeout = 20
relaxdtmf = yes
rtpholdtimeout = 300
rtptimeout = 60

sendrpid = no
sipdebug = no
subscribecontext =
t1min = 100
t38pt_udptl = yes
tos_audio = ef
tos_sip = CS3
tos_video = AF41
trustrpid = no
useragent = SwitchFin PBX
usereqphone = no
videosupport = yes
externhost = This is also set to my DDNS address
localnet = my local net address/255.255.255.0
disallow = all
allow = alaw,ulaw,gsm

TOP

你localnet 一定要SET netmask,而且不是SET 梗咗一個 local IP address 的。

localnet = 192.168.0.38 (wrong setting)

localnet = 192.168.0.0/255.255.255.0 (whole lan segment with netmask is appropriate)

怪不得你經常SIP 的網絡有問題。

TOP

如果設定無誤,正常應該唔需要externhost 及 externip 一齊用的。

TOP

如果設定無誤,正常應該唔需要externhost 及 externip 一齊用的。
bubblestar 發表於 2011-3-5 18:10



Hi bubblestar,
If I used the IP 192.168.1.38, is it need to charge 192.168.1.0/255.255.255.0 ?
Thanks.
smallstarxsc

TOP

Yes, correct.

TOP

Yes, correct.
bubblestar 發表於 2011-3-5 18:52



thanks

TOP

回復 27# smallstarxsc


You are welcome.

Happy sharing

TOP

返回列表